產品規格


 

BMP180 高精度 大氣壓力感應器 高度感應器 模組  

取代BMP085

 

出貨為未焊接版本,代客焊接排針一塊收 5元,10片以上可免費代客焊接,

 

台灣凱斯電子製造               

  • 增加電源指示燈
  • IIC 腳位定義都一致,可連續擴展其它IIC 模組,如IIC 1602 LCM,ADXL345,HMC5883L,MPU6050,BMP180 等其它凱斯電子製造的模組
  • DEMO CODE和使用手冊由凱斯電子編寫

 

 

 

Barometric Pressure Sensor Breakout - BMP180

             

Description:

This is a breakout board for the Bosch BMP180 high-precision, low-power digital barometer. The BMP180 offers a pressure measuring range of 300 to 1100 hPa with an accuracy down to 0.02 hPa in advanced resolution mode. It’s based on piezo-resistive technology for high accuracy, ruggedness and long term stability. These come factory-calibrated, with the calibration coefficients already stored in ROM. What makes this sensor great is that it is nearly identical to its former rev, the BMP085!

This breadboard-friendly board breaks out every pin to a 5-pin 0.1" pitch header. VCC can be from 1.8V to 3.6V and is 5V tolerant; we typically run it on a clean, regulated 3.3V supply. The analog and digital supplies (VDDD and VDDA) are tied to a single header pin, but are separately decoupled. It connects to a microcontroller via I²C bus (also known as TWI, or on the Arduino, the “Wire” library).

 

Features:

Digital two wire (I²C, TWI, “Wire”) interface

Wide barometric pressure range

Flexible supply voltage range (1.8V to 3.6V)

Ultra-low power consumption

Low noise measurements

Factory-calibrated

Includes temperature sensor

Low-profile with a small footprint

 

KSM101 BMP180 大氣壓力感測模組

  • 型 號: 0401210018
  • 庫存狀況: 尚有庫存
  • $TWD100